Resonance in an AC Circuit

In the RLC series circuit of, the current amplitude is, from,

{I}_{0}=\frac{ {V}_{0} }{\sqrt{ {R}^{2}+{(\omega L-1\text{/}\omega C)}^{2} } }.

If we can vary the frequency of the ac generator while keeping the amplitude of its output voltage constant, then the current changes accordingly. A plot of {I}_{0} versus \omega is shown in Figure 15.5.1.

Figure 15.5.1 At an RLC circuit’s resonant frequency, <span class={\omega}_{0}=\sqrt{1\text{/}LC}, the current amplitude is at its maximum value." loading="lazy"/>
Figure 15.5.1 At an RLC circuit’s resonant frequency, {\omega}_{0}=\sqrt{1\text{/}LC}, the current amplitude is at its maximum value.

In Oscillations, we encountered a similar graph where the amplitude of a damped harmonic oscillator was plotted against the angular frequency of a sinusoidal driving force (see Forced Oscillations). This similarity is more than just a coincidence, as shown earlier by the application of Kirchhoff’s loop rule to the circuit of. This yields

L\frac{di}{dt}+iR+\frac{q}{C}={V}_{0}\,\text{sin}\,\omega t,

or

L\frac{ {d}^{2}q}{d{t}^{2} }+R\frac{dq}{dt}+\frac{1}{C}q={V}_{0}\,\text{sin}\,\omega t,

where we substituted dq(t)/dt for i(t). A comparison of and, from Oscillations, Damped Oscillations for damped harmonic motion clearly demonstrates that the driven RLC series circuit is the electrical analog of the driven damped harmonic oscillator.

The resonant frequency {f}_{0} of the RLC circuit is the frequency at which the amplitude of the current is a maximum and the circuit would oscillate if not driven by a voltage source. By inspection, this corresponds to the angular frequency {\omega}_{0}=2\pi{f}_{0} at which the impedance Z in is a minimum, or when

{\omega}_{0}L=\frac{1}{ {\omega}_{0}C}

and

{\omega}_{0}=\sqrt{\frac{1}{LC} }.

This is the resonant angular frequency of the circuit. Substituting {\omega}_{0} into,, and, we find that at resonance,

\phi={\text{tan} }^{-1}(0)=0\text{,}{I}_{0}={V}_{0}\text{/}R,\,\text{and}\,Z=R.

Therefore, at resonance, an RLC circuit is purely resistive, with the applied emf and current in phase.

Register to read the full text

This page shows only part of the content. Register or log in to read it all.

Register / Log in