When the switch is closed in the RLC circuit of Figure 14.6.1(a), the capacitor begins to discharge and electromagnetic energy is dissipated by the resistor at a rate {i}^{2}R. With U given by, we have
\frac{dU}{dt}=\frac{q}{C}\,\frac{dq}{dt}+Li\frac{di}{dt}=\text{-}{i}^{2}Rwhere i and q are time-dependent functions. This reduces to
L\frac{ {d}^{2}q}{d{t}^{2} }+R\frac{dq}{dt}+\frac{1}{C}q=0.This equation is analogous to
m\frac{ {d}^{2}x}{d{t}^{2} }+b\frac{dx}{dt}+kx=0,which is the equation of motion for a damped mass-spring system (you first encountered this equation in Oscillations). As we saw in that chapter, it can be shown that the solution to this differential equation takes three forms, depending on whether the angular frequency of the undamped spring is greater than, equal to, or less than b/2m. Therefore, the result can be underdamped (\sqrt{k\text{/}m}>b\text{/}2m), critically damped (\sqrt{k\text{/}m}=b\text{/}2m), or overdamped (\sqrt{k\text{/}m}<b\text{/}2m). By analogy, the solution q(t) to the RLC differential equation has the same feature. Here we look only at the case of under-damping. By replacing m by L, b by R, k by 1/C, and x by q in, and assuming \sqrt{1\text{/}LC}>R\text{/}2L, we obtain
q(t)={q}_{0}{e}^{\text{-}Rt\text{/}2L}\,\text{cos}(\omega't+\phi)where the angular frequency of the oscillations is given by
{\omega}^{'}=\sqrt{\frac{1}{LC} - {(\frac{R}{2L})}^{2} }This underdamped solution is shown in Figure 14.6.1(b). Notice that the amplitude of the oscillations decreases as energy is dissipated in the resistor. can be confirmed experimentally by measuring the voltage across the capacitor as a function of time. This voltage, multiplied by the capacitance of the capacitor, then gives q(t).
In the interactive circuit construction kit simulation below, you can add inductors and capacitors to work with any combination of R, L, and C circuits with both dc and ac sources. Then you can measure and evaluate current and voltage, and graph them as a function of time.
With the interactive DC circuit construction kit simulation below, you can add inductors and capacitors to work with any combination of R, L, and C circuits with both dc and ac sources. Then you can measure and evaluate current and voltage, and graph them as a function of time.
Register to read the full text
This page shows only part of the content. Register or log in to read it all.
Register / Log in