Electric Generators and Back Emf

A variety of important phenomena and devices can be understood with Faraday’s law. In this section, we examine two of these.

Electric Generators

Electric generators induce an emf by rotating a coil in a magnetic field, as briefly discussed in Motional Emf. We now explore generators in more detail. Consider the following example.

The emf calculated in is the average over one-fourth of a revolution. What is the emf at any given instant? It varies with the angle between the magnetic field and a perpendicular to the coil. We can get an expression for emf as a function of time by considering the motional emf on a rotating rectangular coil of width w and height l in a uniform magnetic field, as illustrated in Figure 13.6.1.

Figure 13.6.1 A generator with a single rectangular coil rotated at constant angular velocity in a uniform magnetic field produces an emf that varies sinusoidally in time. Note the generator is similar to a motor, except the shaft is rotated to produce a current rather than the other way around.
Figure 13.6.1 A generator with a single rectangular coil rotated at constant angular velocity in a uniform magnetic field produces an emf that varies sinusoidally in time. Note the generator is similar to a motor, except the shaft is rotated to produce a current rather than the other way around.

Charges in the wires of the loop experience the magnetic force, because they are moving in a magnetic field. Charges in the vertical wires experience forces parallel to the wire, causing currents. But those in the top and bottom segments feel a force perpendicular to the wire, which does not cause a current. We can thus find the induced emf by considering only the side wires. Motional emf is given to be \varepsilon=Blv, where the velocity v is perpendicular to the magnetic field B. Here the velocity is at an angle \theta with B, so that its component perpendicular to B is v sin \theta (see Figure 13.6.1). Thus, in this case, the emf induced on each side is \varepsilon=Blv\,\text{sin}\,\theta, and they are in the same direction. The total emf around the loop is then

\varepsilon=2Blv\,\text{sin}\,\theta.

This expression is valid, but it does not give emf as a function of time. To find the time dependence of emf, we assume the coil rotates at a constant angular velocity \omega. The angle \theta is related to angular velocity by \theta=\omega t, so that

\varepsilon=2Blv\,\text{sin}(\omega t).

Now, linear velocity v is related to angular velocity \omega by v=r\omega. Here, r=w\text{/}2, so that v=(w\text{/}2)\omega, and

\varepsilon=2Bl\frac{w}{2}\omega\,\text{sin}\,\omega t=(lw)B\omega\,\text{sin}\,\omega t.

Noting that the area of the loop is A=lw, and allowing for N loops, we find that

\varepsilon=NBA\omega\,\text{sin}(\omega t).

This is the emf induced in a generator coil of N turns and area A rotating at a constant angular velocity \omega in a uniform magnetic field B. This can also be expressed as

\varepsilon={\varepsilon}_{0}\,\text{sin}\,\omega t,

where

{\varepsilon}_{0}=NAB\omega

is the peak emf, since the maximum value of \sin(wt)=1. Note that the frequency of the oscillation is f=\omega\text{/}2\pi and the period is T=\text{1/}f=2\pi\text{/}\,\omega. Figure 13.6.2 shows a graph of emf as a function of time, and it now seems reasonable that ac voltage is sinusoidal.

Register to read the full text

This page shows only part of the content. Register or log in to read it all.

Register / Log in