Lenz's Law

The direction in which the induced emf drives current around a wire loop can be found through the negative sign. However, it is usually easier to determine this direction with Lenz’s law, named in honor of its discoverer, Heinrich Lenz (1804–1865). (Faraday also discovered this law, independently of Lenz.) We state Lenz’s law as follows:

Lenz’s Law

The direction of the induced emf drives current around a wire loop to always oppose the change in magnetic flux that causes the emf.

Lenz’s law can also be considered in terms of conservation of energy. If pushing a magnet into a coil causes current, the energy in that current must have come from somewhere. If the induced current causes a magnetic field opposing the increase in field of the magnet we pushed in, then the situation is clear. We pushed a magnet against a field and did work on the system, and that showed up as current. If it were not the case that the induced field opposes the change in the flux, the magnet would be pulled in and produce a current without any work. Electric potential energy would have been created, violating the conservation of energy.

To determine an induced emf \varepsilon, you first calculate the magnetic flux {\Phi}_{\text{m} } and then obtain d{\Phi}_{\text{m} }\text{/}dt. The magnitude of \varepsilon is given by \varepsilon=|d{\Phi}_{\text{m} }\text{/}dt|. Finally, you can apply Lenz’s law to determine the sense of \varepsilon. This will be developed through examples that illustrate the following problem-solving strategy.

Lenz’s Law

To use Lenz’s law to determine the directions of induced magnetic fields, currents, and emfs:

  1. Make a sketch of the situation for use in visualizing and recording directions.
  2. Determine the direction of the applied magnetic field \mathbf{\vec{B} }.
  3. Determine whether its magnetic flux is increasing or decreasing.
  4. Now determine the direction of the induced magnetic field \mathbf{\vec{B} }. The induced magnetic field tries to reinforce a magnetic flux that is decreasing or opposes a magnetic flux that is increasing. Therefore, the induced magnetic field adds or subtracts to the applied magnetic field, depending on the change in magnetic flux.

Register to read the full text

This page shows only part of the content. Register or log in to read it all.

Register / Log in