We can understand the effect of a dielectric on capacitance by looking at its behavior at the molecular level. As we have seen in earlier chapters, in general, all molecules can be classified as either polar or nonpolar. There is a net separation of positive and negative charges in an isolated polar molecule, whereas there is no charge separation in an isolated nonpolar molecule (Figure 8.5.1). In other words, polar molecules have permanent electric-dipole moments and nonpolar molecules do not. For example, a molecule of water is polar, and a molecule of oxygen is nonpolar. Nonpolar molecules can become polar in the presence of an external electrical field, which is called induced polarization.
Let’s first consider a dielectric composed of polar molecules. In the absence of any external electrical field, the electric dipoles are oriented randomly, as illustrated in Figure 8.5.2(a). However, if the dielectric is placed in an external electrical field {\mathbf{\vec{E} } }_{0}, the polar molecules align with the external field, as shown in part (b) of the figure. Opposite charges on adjacent dipoles within the volume of dielectric neutralize each other, so there is no net charge within the dielectric (see the dashed circles in part (b)). However, this is not the case very close to the upper and lower surfaces that border the dielectric (the region enclosed by the dashed rectangles in part (b)), where the alignment does produce a net charge. Since the external electrical field merely aligns the dipoles, the dielectric as a whole is neutral, and the surface charges induced on its opposite faces are equal and opposite. These induced surface charges +{Q}_{i} and \text{-}{Q}_{i} produce an additional electrical field {\mathbf{\vec{E} } }_{\text{i} } (an induced electrical field), which opposes the external field {\mathbf{\vec{E} } }_{0}, as illustrated in part (c).
The same effect is produced when the molecules of a dielectric are nonpolar. In this case, a nonpolar molecule acquires an induced electric-dipole moment because the external field {\mathbf{\vec{E} } }_{0} causes a separation between its positive and negative charges. The induced dipoles of the nonpolar molecules align with {\mathbf{\vec{E} } }_{0} in the same way as the permanent dipoles of the polar molecules are aligned (shown in part (b)). Hence, the electrical field within the dielectric is weakened regardless of whether its molecules are polar or nonpolar.
Therefore, when the region between the parallel plates of a charged capacitor, such as that shown in Figure 8.5.3(a), is filled with a dielectric, within the dielectric there is an electrical field {\mathbf{\vec{E} } }_{0} due to the free charge {Q}_{0} on the capacitor plates and an electrical field {\mathbf{\vec{E} } }_{\text{i} } due to the induced charge {Q}_{i} on the surfaces of the dielectric. Their vector sum gives the net electrical field \mathbf{\vec{E} } within the dielectric between the capacitor plates (shown in part (b) of the figure):
\mathbf{\vec{E} }={\mathbf{\vec{E} } }_{0}+{\mathbf{\vec{E} } }_{\text{i} }.This net field can be considered to be the field produced by an effective charge {Q}_{0} - {Q}_{i} on the capacitor.
In most dielectrics, the net electrical field \mathbf{\vec{E} } is proportional to the field {\mathbf{\vec{E} } }_{0} produced by the free charge. In terms of these two electrical fields, the dielectric constant \kappa of the material is defined as
\kappa=\frac{ {E}_{0} }{E}.Since {\mathbf{\vec{E} } }_{0} and {\mathbf{\vec{E} } }_{\text{i} } point in opposite directions, the magnitude E is smaller than the magnitude {E}_{0} and therefore \kappa>1. Combining with, and rearranging the terms, yields the following expression for the induced electrical field in a dielectric:
Register to read the full text
This page shows only part of the content. Register or log in to read it all.
Register / Log in