When an ideal gas is compressed adiabatically (Q=0), work is done on it and its temperature increases; in an adiabatic expansion, the gas does work and its temperature drops. Adiabatic compressions actually occur in the cylinders of a car, where the compressions of the gas-air mixture take place so quickly that there is no time for the mixture to exchange heat with its environment. Nevertheless, because work is done on the mixture during the compression, its temperature does rise significantly. In fact, the temperature increases can be so large that the mixture can explode without the addition of a spark. Such explosions, since they are not timed, make a car run poorly—it usually “knocks.” Because ignition temperature rises with the octane of gasoline, one way to overcome this problem is to use a higher-octane gasoline.
Another interesting adiabatic process is the free expansion of a gas. Figure 3.6.1 shows a gas confined by a membrane to one side of a two-compartment, thermally insulated container. When the membrane is punctured, gas rushes into the empty side of the container, thereby expanding freely. Because the gas expands “against a vacuum” (p=0), it does no work, and because the vessel is thermally insulated, the expansion is adiabatic. With Q=0 and W=0 in the first law, \Delta{E}_{\text{int} }=0, so {E}_{\text{int} }{}_{i}={E}_{\text{int} }{}_{f} for the free expansion.
If the gas is ideal, the internal energy depends only on the temperature. Therefore, when an ideal gas expands freely, its temperature does not change.
A quasi-static, adiabatic expansion of an ideal gas is represented in Figure 3.6.2, which shows an insulated cylinder that contains an ideal gas. The gas is made to expand quasi-statically by removing one grain of sand at a time from the top of the piston. When the gas expands by dV, the change in its temperature is dT. The work done by the gas in the expansion is dW=pdV;dQ=0 because the cylinder is insulated; and the change in the internal energy of the gas is, from, d{E}_{\text{int} }=n{C}_{V}dT. Therefore, from the first law,
n{C}_{V}dT=0-pdV=\text{-}pdV,so
dT=-\frac{pdV}{n{C}_{V} }.Also, for an ideal gas,
d(pV)=d(nRT),so
pdV+Vdp=nRdTand
dT=\frac{pdV+Vdp}{nR}.We now have two equations for dT. Upon equating them, we find that
n{C}_{V}Vdp+(n{C}_{V}+nR)pdV=0.Now, we divide this equation by npV and use {C}_{p}={C}_{V}+R. We are then left with
{C}_{V}\frac{dp}{p}+{C}_{p}\frac{dV}{V}=0,which becomes
\frac{dp}{p}+\gamma\frac{dV}{V}=0,where we define \gamma as the ratio of the molar heat capacities:
\gamma=\frac{ {C}_{p} }{ {C}_{V} }.Thus,
\int\frac{dp}{p}+\gamma\int\frac{dV}{V}=0and
\text{ln}\,p+\gamma\text{ln}\,V=\text{constant}\text{.}Finally, using \text{ln}({A}^{x})=x\text{ln}A\,\text{and}\,\text{ln}\,AB=\text{ln}\,A+\text{ln}\,B, we can write this in the form
p{V}^{\gamma}=\text{constant}\text{.}This equation is the condition that must be obeyed by an ideal gas in a quasi-static adiabatic process. For example, if an ideal gas makes a quasi-static adiabatic transition from a state with pressure and volume {p}_{1} and {V}_{1} to a state with {p}_{2} and {V}_{2}, then it must be true that {p}_{1}{V}_{1}^{\gamma}={p}_{2}{V}_{2}^{\gamma}.
The adiabatic condition of can be written in terms of other pairs of thermodynamic variables by combining it with the ideal gas law. In doing this, we find that
{p}^{1-\gamma}{T}^{\gamma}=\text{constant}and
T{V}^{\gamma-1}=\text{constant}\text{.}A reversible adiabatic expansion of an ideal gas is represented on the pV diagram of Figure 3.6.3. The slope of the curve at any point is
\frac{dp}{dV}=\frac{d}{dV}(\frac{\text{constant} }{ {V}^{\gamma} })=\text{-}\gamma\frac{p}{V}.The dashed curve shown on this pV diagram represents an isothermal expansion where T (and therefore pV) is constant. The slope of this curve is useful when we consider the second law of thermodynamics in the next chapter. This slope is
\frac{dp}{dV}=\frac{d}{dV}\,\frac{nRT}{V}=-\frac{p}{V}.Because \gamma>1, the isothermal curve is not as steep as that for the adiabatic expansion.
Register to read the full text
This page shows only part of the content. Register or log in to read it all.
Register / Log in