Bernoulli’s Equation in University Physics

As we showed in, when a fluid flows into a narrower channel, its speed increases. That means its kinetic energy also increases. The increased kinetic energy comes from the net work done on the fluid to push it into the channel. Also, if the fluid changes vertical position, work is done on the fluid by the gravitational force.

A pressure difference occurs when the channel narrows. This pressure difference results in a net force on the fluid because the pressure times the area equals the force, and this net force does work. Recall the work-energy theorem,

{W}_{\text{net} }=\frac{1}{2}m{v}^{2}-\frac{1}{2}m{v}_{0}^{2}.

The net work done increases the fluid’s kinetic energy. As a result, the pressure drops in a rapidly moving fluid whether or not the fluid is confined to a tube.

There are many common examples of pressure dropping in rapidly moving fluids. For instance, shower curtains have a disagreeable habit of bulging into the shower stall when the shower is on. The reason is that the high-velocity stream of water and air creates a region of lower pressure inside the shower, whereas the pressure on the other side remains at the standard atmospheric pressure. This pressure difference results in a net force, pushing the curtain inward. Similarly, when a car passes a truck on the highway, the two vehicles seem to pull toward each other. The reason is the same: The high velocity of the air between the car and the truck creates a region of lower pressure between the vehicles, and they are pushed together by greater pressure on the outside (Figure 14.6.1). This effect was observed as far back as the mid-1800s, when it was found that trains passing in opposite directions tipped precariously toward one another.

Figure 14.6.1 An overhead view of a car passing a truck on a highway. Air passing between the vehicles flows in a narrower channel and must increase its speed (<span class={v}_{2} is greater than {v}_{1}), causing the pressure between them to drop ({p}_{\text{i} } is less than {p}_{\text{o} })\text{.} Greater pressure on the outside pushes the car and truck together." loading="lazy"/>
Figure 14.6.1 An overhead view of a car passing a truck on a highway. Air passing between the vehicles flows in a narrower channel and must increase its speed ({v}_{2} is greater than {v}_{1}), causing the pressure between them to drop ({p}_{\text{i} } is less than {p}_{\text{o} })\text{.} Greater pressure on the outside pushes the car and truck together.

Energy Conservation and Bernoulli’s Equation

The application of the principle of conservation of energy to frictionless laminar flow leads to a very useful relation between pressure and flow speed in a fluid. This relation is called Bernoulli’s equation, named after Daniel Bernoulli (1700–1782), who published his studies on fluid motion in his book Hydrodynamica (1738).

Consider an incompressible fluid flowing through a pipe that has a varying diameter and height, as shown in Figure 14.6.2. Subscripts 1 and 2 in the figure denote two locations along the pipe and illustrate the relationships between the areas of the cross sections A, the speed of flow v, the height from ground h, and the pressure p at each point. We assume here that the density at the two points is the same—therefore, density is denoted by \rho without any subscripts—and since the fluid is incompressible, the shaded volumes must be equal.

Figure 14.6.2 The geometry used for the derivation of Bernoulli’s equation.
Figure 14.6.2 The geometry used for the derivation of Bernoulli’s equation.

We also assume that there are no viscous forces in the fluid, so the energy of any part of the fluid will be conserved. To derive Bernoulli’s equation, we first calculate the work that was done on the fluid:

dW={F}_{1}d{x}_{1} - {F}_{2}d{x}_{2} dW={p}_{1}{A}_{1}d{x}_{1} - {p}_{2}{A}_{2}d{x}_{2}={p}_{1}dV- {p}_{2}dV=({p}_{1} - {p}_{2})dV.

The work done was due to the conservative force of gravity and the change in the kinetic energy of the fluid. The change in the kinetic energy of the fluid is equal to

dK=\frac{1}{2}{m}_{2}{v}_{2}^{2}-\frac{1}{2}{m}_{1}{v}_{1}^{2}=\frac{1}{2}\rho dV({v}_{2}^{2} - {v}_{1}^{2}).

The change in potential energy is

dU=mg{h}_{2}-mg{h}_{1}=\rho dVg({h}_{2} - {h}_{1}).

The energy equation then becomes

\begin{aligned}dW & = & dK+dU \\ ({p}_{1} - {p}_{2})dV & = & \frac{1}{2}\rho dV({v}_{2}^{2} - {v}_{1}^{2})+\rho dVg({h}_{2} - {h}_{1}) \\ ({p}_{1} - {p}_{2}) & = & \frac{1}{2}\rho({v}_{2}^{2} - {v}_{1}^{2})+\rho g({h}_{2} - {h}_{1}).\end{aligned}

Rearranging the equation gives Bernoulli’s equation:

{p}_{1}+\frac{1}{2}\rho{v}_{1}^{2}+\rho g{h}_{1}={p}_{2}+\frac{1}{2}\rho{v}_{2}^{2}+\rho g{h}_{2}.

This relation states that the mechanical energy of any part of the fluid changes as a result of the work done by the fluid external to that part, due to varying pressure along the way. Since the two points were chosen arbitrarily, we can write Bernoulli’s equation more generally as a conservation principle along the flow.

Bernoulli’s Equation

Register to read the full text

This page shows only part of the content. Register or log in to read it all.

Register / Log in