Conservative and Non-Conservative Forces

In the interactions we considered in Potential Energy and Conservation of Energy, any transition between kinetic and potential energy did not change the total energy of the system. This was path independent, meaning that we can start and stop at any two points in the problem, and the total energy of the system—kinetic plus potential—at these points are equal to each other. This is characteristic of a conservative force. We dealt with conservative forces in the preceding section, such as the gravitational force and spring force. When comparing the motion of the football in, the total energy of the system never changes, even though the gravitational potential energy of the football increases, as the ball rises relative to ground and falls back to the initial gravitational potential energy when the football player catches the ball. Non-conservative forces and the work that they do are path dependent. Dissipative forces such as friction or air resistance, for example, are non-conservative. These forces take energy away from the system as the system progresses; energy that you can’t get back. Push-pull forces are also generally non-conservative. Imagine pushing a merry-go-round. The total work done in returning to the starting point depends on how many revolutions are completed, and therefore the total energy at that location is not constant.

Conservative Force

The work done by a conservative force is independent of the path; in other words, the work done by a conservative force is the same for any path connecting two points:

{W}_{AB,\text{path}\text{-}1}=\underset{AB,\text{path}\text{-}1}{\int}{\vec{\vec{F} } }_{\text{cons} }\cdot d\vec{\vec{r} }={W}_{AB,\text{path}\text{-}2}=\underset{AB,\text{path}\text{-}2}{\int}{\vec{\vec{F} } }_{\text{cons} }\cdot d\vec{\vec{r} }.

The work done by a non-conservative force depends on the path taken.

Equivalently, a force is conservative if the work it does around any closed path is zero:

{W}_{\text{closed path} }=∮{\mathbf{\vec{F} } }_{\text{cons} }\cdot d\mathbf{\vec{r} }=0.

[In, we use the notation of a circle in the middle of the integral sign for a line integral over a closed path, a notation found in most physics and engineering texts.] and are equivalent because any closed path is the sum of two paths: the first going from A to B, and the second going from B to A. The work done going along a path from B to A is the negative of the work done going along the same path from A to B, where A and B are any two points on the closed path:

Register to read the full text

This page shows only part of the content. Register or log in to read it all.

Register / Log in